How to open or start a pool on SpringStarting or opening a pool is quite simple. But it requires a little work and an extra pair of, above ground pool heater, hands, he said. Honestly, it is better to initially build one or two weeks before opening, not only to obtain better results, but also to some stress away.No last minute to bring, pool heater, the case if you have a pool or pool on the floor buried have the basic work is the same or similar. Follow these simple steps with details and tips: Remove all leaves, dirt and dust from the winter before removal.
I can not tell you how many times I've seen people leave the whole mess in the winter to go right into the pool! Speaking of extra work. I've seen really 'clean' water winter turned to the "tea" and the debris of winter cover black. Take a couple of hours digging and collecting half the excess of leaves in the upper eyelid. Remember, not only the leaves in the autumn of last year, the tree pollen in the spring "helicopters", above ground pool heater, and pine needles all winter too.
Remove and ice anchors (gizzmo). You can not start the pump and filter system, where water flows from the pool filter and back! Turn back to the respective addresses (eyes), suction (usually used in low vacuum) to replace the pump seals, etc. If under normal use, eyes fixed, remember to optimize the flow of water in the bottom pool point for the movement. To the movement, better yet, consider replacing the rudder with the bomb "" to return. Bring water to the level of normal operating conditions.
If the water is at the top of the deck relatively clean and free of algae, to fill the water use for the pool. It's free! Can a little 'dirty, but hopefully with the rest of the pool are treated. It is now really a good idea, as an algaecide to add the swimming pool or a natural enzyme to start the water and during the preparation for the first shock. If you keep fresh water outdoor pool, add a good metal and mineral products, control of stain and scale to sudden splash of metals, especially iron or copper, if the group is Winter shocked.
Carefully first remove top cover. Clean, folded and tied. Clean with a good cleanser, especially for coating material. A chemical cleaning of winter good coverage can extend the life of the cover, remove dirt and the floor of the fabric (which are not done correctly in the laundry room for the next season?) Close the filter system. Is it right, or, above ground pool heater, piping,, pool heater, valves and fittings at the pump and filter attack. I also, above ground pool heater, made this error: the tube on the right goes wrong and the filter unit two weeks later, the pool is not clear!
This is the easiest way to, above ground pool heater, remember: basketball (basket of the skimmer basket) and back hole hole (exit – sharing – opening the tank valve or the filter body to the opening of the pool wall and is). Be sure to lubricate all of the right valve or multi-port "O" ring with a good silicone lubricant. It provides not only the life of the board have to help block light. Do not tighten the clamps too tight in the pipes above ground, often attracted to "press" that the hose can be used for air leaks.
REMEMBER replace: all drain plugs in the pump, filter and heater tank (if any). When the pump is started for the first time, be sure to "prepare" the water pump . Do not start too dry, not only at the pump, the extra effort and emphasis is placed on the damage to the entire system. If your pump below the water table, as in most pools above ground, activation is probably not necessary because the water is, of course, "Falling Down" at the pump (gravity feed). If the pump and filter system is more than 3 m above the water level is the trigger is a necessity.
Please note that The system may take several minutes to collect and start.SPECIAL NOTE: for many air bubbles connections when returned from the first normal. Even with a maximum of 24-36 hours,, above ground pool heater, air bubbles in the hydraulic system is maintained, and returns to normal operation. Tip: To make it easier to start the filter, open the "bleeding" air valve at the top of the tank filter if the filter starts.
